shared code doesnt work
- This topic has 4 replies, 1 voice, and was last updated 8 years, 9 months ago by
.
-
Posts
-
andersem
I received a code from a lab that is the exact procedure I was looking to use. When I translate, compile, and try to run the procedure nothing happens. The house light does not even turn on. In the gray grid in upper left of the med-pc screen it does not show as if the program in interacting with the interface. Similarly, when running the program the interface does not light up for any of the boxes. I ran another one of our programs and that worked fine so it is something with this specific program and I cannot figure out what. The outputs are all correct as well. Any help would be great, thanks.
Gary Bamberger
Hello,
Unfortunately I don’t have enough information to be able to tell you what the exact problem is, but maybe I can give you a troubleshooting tip:After you START the program in MED-PC IV you can go to menu “View | State Sets.” This will list the State that each State Set is in. This may give you a clue as to where the program is stuck.
In order to help any further I would need a copy of the program.
Garyandersem
It works! Thanks so much for the help. I did not realize that the acclimation period was written into the code and was not patient enough to let it run for five minutes. Thanks for your help again!
Eden
- You must be logged in to reply to this topic.